Basic Setup - CARLO GAVAZZI G3800 X015 - CONFIGURATION SOFTWARE User Manual

Configuration software
Table of Contents

Advertisement

G 3800 X015 Configuration Software
October 2002

1.3. Basic Setup

General description
The text window is for entering general information, eg name of user, date of configuration, reference to docu-
mentation, etc.
No. of channels
For selection of the number of channels desired in the system. The minimum is 8, the maximum is 128 in one
Dupline network.
Auto-start Dupline on short-circuit
In case of a short-circuit on Dupline, the Generator shuts down the Dupline signal. Under default conditions,
power-off followed by power-on needs to be performed to reset the Generator after removal of the short-cir-
cuit. However, if the "Auto-start Dupline on short-circuit" box is checked, then the Generator will automatically
start up the Dupline signal after removal of the short-circuit.
Enable automatic update of realtime status upon Config-download and System power-up
If this box is checked, the Generator will automatically set the correct status for realtime channels according
to the switch-time settings, provided that the actual Day of the week matches the internal Day of the week of
the Generator. Also, the Generator will only scan the switch times (ON or OFF) for that same day.
Enable Automatic Daylight saving. Central European Time standard
If this box is checked, the Generator will automatically change the time settings 2 times per year according to
the European standard for daylight savings.
Enable RTC Powerline Autocalibration
Selecting Auto-calibrate, will enable the internal Realtime clock to adjust its internal calibration against the
Mains-supply frequency. In most countries, the Mains-supply frequency is very accurate, and in that case an
improved accuracy on the Realtime clock can be achieved.
Syncronize Time to PC date and Time
If this button is activated when the Generator is connected to the PC, then the PC date and time will be trans-
ferred to the realtime clock of the Generator.
10
© 2002 Carlo Gavazzi Industri A/S. All rights reserved

Hide quick links:

Advertisement

Table of Contents
loading

Related Products for CARLO GAVAZZI G3800 X015 - CONFIGURATION SOFTWARE

This manual is also suitable for:

G 3800 x015

Table of Contents