Configuring Port Clustering - Digi CM User Manual

Configuring Port Clustering

Configuring Port Clustering
Assigning Master Clustering Mode
To assign a Digi CM as the master cluster device, do the following:
1. Access the Digi CM through the web interface. This Digi CM needs to be
2. Under the Clustering heading, choose Configuration.
3. Choose Master from the drop down menu.
4. Choose Save & apply.
Configuring Slave Ports on the Master Unit with Auto Config
Ports on slave units are automatically enabled and set to the Telnet protocol. If
you want to disable some or all of the ports or you want to use a different
protocol, make these changes to the slave units before you autoconfigure the
slave ports on the master unit.
To configure the slave serial ports on the master unit, do the following:
1. Access the Digi CM through the web interface.
2. Under the Clustering heading, choose Configuration.
3. Select the hyperlinked letter under Unit ID or the dashed line under IP
104
the unit you want as the Master.
Subsequent units will be configured in Slave mode by default.
address.
Chapter 13