Configuring Smtp Alerts; Snmp Information - Digi CM User Manual

Configuring SMTP Alerts

Configuring SMTP Alerts
Most SMTP servers check the sender's email address with the host domain
name to verify the address as authentic. Consequently, when assigning an
email address for the device email address, any arbitrary username with the
registered hostname may be used. An example is username@company.com.
To configure the Digi CM for SMTP alerts, the following parameters are required:
To configure SMTP alerts on the Digi CM, do the following:
1. Access the web interface.
2. Under the Network heading, choose SMTP configuration.
3. Fill in the required fields. SMTP with authentication and POP before SMTP
4. Click Save & apply.

SNMP Information

Applications such as NMS (Network Management System) or an SNMP
browser can exchange information with the Digi CM and control actions to the
The Digi CM
unit. The protocol functions defined for SNMP includes GET, SET, GET-Next,
supports SNMP
authentication,
GET-Bulk, and TRAP. Below are the definitions of the protocol functions found
power on, and
in SNMP. Authentication, power on, and link up traps are supported.
link up traps.
.
52
- Use either the hostname or the IP address.
SMTP server
- Specify the sender's email address for the log and
Device mail address
alarm delivery.
- Specify the type of SMTP server to use.
SMTP mode
Username and password
and SMTP with authentication servers.
require usernames and passwords.
Protocol
GET Queries a device for more information
SET Makes changes to a device's state
GET-Next After an initial GET query, goes to the next value
GET-Bulk Retrieves tables of information and security functions
TRAP Notifies a system administrator of a significant event
- These fields are required for POP before SMTP
Function
Chapter 5