Configuring System Logging - Digi CM User Manual

Configuring System Logging

Enable Digi CM Memory
The Digi CM memory is already enabled for port logging and only needs to be
configured for system or port logging. When storing log files to the Digi CM
local memory, a total of 3.5M is available. The amount of memory per serial
port is dependent on the port count of the Digi CM used. The log file sizes are
shown in the following table are maximum settings. See also Configuring
System Logging on page 36.
Configuring System Logging
To configure the Digi CM for system logging, do the following:
1. Access the web interface.
2. Under System status & log, click System logging.
3. Choose Enabled for System logging and the log buffer size.
4. From the System log storage location, choose the location you want from
36
Digi CM
8
16
32
48
the drop down menu. The choices available are dependent on what you
have enabled and/or installed. The Digi CM memory choice is always
available.
- Enable or Disable
System logging
System log storage location
System log to SYSLOG server
server
System log buffer size (KB, 300 max) -
Send system log by Email
Number of log messages to send a mail (1-100)
Port Log
System Log
(per port)
400K
200K
300K
100K
66K
- Memory or NFS server
- Enable to store system logs to a SYSLOG
Log buffer size in KB
- Enable or Disable
Total Memory Used
3.5M
- Number of messages
Chapter 5