Table of Contents
Advertisement
MAX-CSE Specifications (Cont.)
Supported Audio Codecs:
Front Panel Components:
ID pushbutton:
Status LED:
LCD Display:
IR Receiver:
Rear Panel Connectors:
COMPOSITE IN:
12VDC PWR:
S-VIDEO IN:
ETHERNET 10/100:
AUDIO R/L:
RS-232/422/485:
MIC:
IR/Serial:
MAX Video Encoder
• MPEG Audio Level 2 (MP2)
• MPEG Audio Level 3 (MP3)
• Used to set the NetLinx ID (Device only) assignment and reset the unit
to factory defaults.
• Press and hold this button for at least 10 seconds to set the unit back to
its default settings.
• Green LED blinks to indicate both the system and communication status
with the target Master.
• Green LED provides an indication of both the system status and
communication status with the target Master.
- 1 blink every 5 seconds indicates there is currently active
communication between the CSE and a target Master.
• Provides system information such as the currently used IP Address.
• Receives 38KHz AMX IR codes.
• BNC connector (female) supports Composite Video Input (NTSC/PAL).
• 2-pin 3.5mm mini-Phoenix (male) captive-wire connector for power from
an optional 12 VDC-compliant power supply (overrides POE).
• Mini-Din4 port for composite S-Video input.
• RJ-45 port provides 10/100 Mbps network communication and POE.
LEDs show communication activity, connection status, speeds, and
mode information:
- SPD (speed) - Yellow LED lights On when the connection speed is
100 Mbps and turns Off when the speed is 10 Mbps.
- L/A (link/activity) - Green LED lights On when the Ethernet cables
are connected/terminated correctly, and then blinks when receiving
Ethernet data packets.
• This port automatically negotiates the connection speed
(10 Mbps or 100 Mbps), and whether to use half or full duplex mode.
• Two RCA connectors support line-level stereo input for analog stereo
signals.
• 9-pin (DB9) port supports RS-232/RS-422/RS-485 data output including:
- 300, 600, 1,200, 2,400, 4,800, 9,600, 19,200, 38,400, and 115,200
Baud rates
- 8 or 9 Data bits
- 1 or 2 Stop bits
- Even, Odd, Mark, Space, and None parity settings
- CTS and RTS handshaking
- XON/XOFF handshaking
• 1/8" mini-stereo input jack.
• 2-pin 3.5mm mini-Phoenix (male) captive-wire connector provides
IR/Serial control output by generating IR with the use of an IR Emitter
(while in IR mode).
• This port supports high-frequency carriers of up to 1.142 MHz and can
also generate IR with no carrier frequency.
MAX Video Encoder
3
Advertisement
Table of Contents
