Step 2: Configuring The Max-Cse For Communication - AMX MAX-CSD ENCODER Instruction Manual

FIG. 39 Setup page
3. Enter 1988 into the Keypad's password field and press Done when finished.
4. Press the System Connection button (located on the Protected Setup page) to open the System
Connection page and obtain the IP information from the IP Address field (FIG. 40).
Modero
IP Address
information
FIG. 40 System Connection page

Step 2: Configuring the MAX-CSE for communication

1. Complete the procedures outlined within the Configuring the MAX Communication
Parameters section on page 40 to establish an active connection to the source MAX-CSE.
2. Confirm the MAX-CSE is properly configured to use the newly established Static IP Address
by launching your browser and entering the MAX's new Static IP Address into the browser's
Address field.
3. Press the Enter key on your keyboard to initiate the communication process and launch the
initial on-screen Enter Network Password security dialog.
4. Enter the words administrator and password (if using the default login profile) into the
corresponding User Name/Password fields. This is the factory default security login
information.
5. Click OK to enter the information and proceed to the Administration page which provides both
a descriptive overview of the program stream and lists the currently used firmware.
MAX Video Encoder
Displaying Stream Content
Connection Status
Red Connection Status icon -
indicates no connection to a Master
Green Connection Status icon -
indicates communication to a Master
57