AMX MAX-CSD ENCODER Instruction Manual page 25

Administration Page Features (Cont.)
Feature
Stream Status frame (Cont.):
Status
Video Sync
Refresh
Active Page frame:
MAX Video Encoder
Description
• Indicates the status of the outgoing stream.
• Streaming indicates that the Play button has been activated
and the process of converting A/V content into an outgoing
media stream has begun. Streaming does not require that
content be provided to the unit, it is only the conversion
process which has been initiated. This is why it is important to
make sure that the unit is also detecting an incoming A/V feed.
• Idle indicates that the Stop button has been activated and the
stream process has been halted.
• Indicates whether the unit is detecting an incoming A/V signal
through its rear connectors.
• SYNC indicates that the incoming A/V signals have been
detected and then synchronized prior to being streamed out
from the MAX-CSE.
• LOS (Loss Of Signal) indicates there is no incoming signal
being detected by the unit and therefore, the outgoing stream
contains no data. Remember, a stream can be initiated and
maintained without there being any signal fed into the unit. It is
important to verify the status of the incoming signal.
• This button causes the unit to re-verify the condition/state of
both the stream Status and Video Sync.
• If you have already initiated a stream and get a
you can try to correct the problem and click the Refresh button
to try and verify the condition of the incoming A/V signal without
needing to Stop the stream process.
Located on the right side of the browser window, this dynamic
frame displays the pages corresponding to the currently selected
option from within the Navigation frame. The top of these pages
also provide the user with some common application buttons
such as Apply and Refresh.
• Since this frame is dynamically populated, its contents will
depend on which Navigation link was currently selected.
MAX-CSE Web Interface
LOS message,
19