Table of Contents
Advertisement
IP Address
information
FIG. 41
System Settings page
Configuring the MAX-CSE for communication
1. Complete the procedures outlined within the Configuring the MAX Communication
Parameters section on page 50 to establish an active connection to the source MAX-CSE.
2. Confirm the MAX-CSE is properly configured to use the newly established Static IP Address by
launching your browser and entering the MAX's new Static IP Address into the browser's Address
field.
3. Press the Enter key on your keyboard to initiate the communication process and launch the initial
on-screen Enter Network Password security dialog.
4. Enter the words administrator and password (if using the default login profile) into the
corresponding User Name/Password fields. This is the factory default security login information.
5. Click OK to enter the information and proceed to the Administration page which provides both a
descriptive overview of the program stream and lists the currently used firmware.
6. Determine the data throughput available on the network being used by the source encoder. This
information determines which Encoder Profile and Transport Protocol will be used to encode the
outgoing media stream.
7. Access Stream Profiles page (FIG. 42) by clicking the Stream Profiles button in the Navigation
Bar. This page allows a user to both configure the properties of the outgoing media stream and setup
the properties associated with communicating the stream to an external IP-enabled device capable
of receiving and processing the data.
MAX-CSE/MAX-CSD10 Operation/Reference Guide
Modero
Displaying Stream Content
65
Advertisement
Table of Contents
