TYAN TEMPEST II Manual page 65

9A Return after seting timer and printer base address. Going to
set the RS-232 badse address.
9B Return after RS-232 Base address. Going to do any Inint.
before CO-processor test.
9C Required Init. before co-processor is over. Going to init. the
co-processor next.
9D Coprocessor init. going to do any init. after co-processor test.
9E Init. after co-processor test is done. Going to check extd
KB, KB ID and num-lock.
9F Exts KB check is done, ID flag set, num-lock ON/OFF.
KB ID command to be issued.
A1 KB ID flag reset. Cache memoey test next.
A2 Cache memory test over. Going to display any soft error.
A3 Soft error display message. Going to set the KB typematic
rate.
A4 KB typematic rate set. Going to program memory wait state.
A5 Memory wait state programming over.Going toclear the
screen and enable parity, NMI.
A7 NMI and parity enable. Going to do any Init. required before
given control to optional ROM at E000.
A8 Init. before E000 ROM control over. E000 rROM to get
control next
A9 Return from E000 ROM control. Going to do any init.
required after E000 optional ROM control.
AA Init. after E000 optional ROM control is over. Going to
display the system configuration.
B0 System configuration is display. Going to uncompress SET
UP code for hot-key setup.
B1 Uncompressing od SETUP code is done. Going to copy any
code to specific area.
00 Copying of code to specific area done. Going to give control
to INT 19 boot loader.
S1642-001-01 65