TYAN TEMPEST II Manual page 62

39 Display different BUSes Init. error message.
3A New cursor position read and saved. Going to display Hit
<DEL> messsage.
3B Hit <DEL> message display. Virtual mode memory test about
to start.
40 Going to prepare the descriptor table.
42 Descriptor tables prepared.Going to enter in vitual mode for
memory test.
43 Entered in the virtual mode. Going to enable interrupt for
diadnostics mode.
44 Interrupts enable. Going to Init. data to check memory wrap
around at 0:0.
45 Data Init.. Going to check for memory wrap arround at 0:0
and finding the total system memory size.
46 Memory wrap around test done. Memory size calculation
over. About to go for write pattern to test memory.
47 Pattern to be tested written in extended memory.Going to
write pattern in base 640K memory.
48 Patterns written in base memory. Going to findout amount of
momeory below 1M memory.
49 Amount of memory below 1M found and verified. Going to
findout amount of memory above 1M memory.
4B Amount of memory above 1M found and verified. Check for
soft reset and going to clear memory below 1M for soft reset.
4C Memory below 1M cleared. Going to clear memory above
1M.
4D Memory above 1M cleared. Going to save the memopry size.
4E Memory test started. about to display the first 64K memory
size.
4F Memory size display started. This will be update during
memory test. Going for sequential and random memory
test.
.
S1462-001-01 62