TYAN TEMPEST II Manual page 43

Floppy Driver Seek At Boot
When Enabled, WINBIOS performs a Seek command on the
floppy drive A: before booting the system. The Optimal and
Fail-Safe default settings are Enable.
Floppy Driver Swapping
The settings are Enable or Disable. The Optimal and Fail-Safe
default settings are Disable.
System Boot up Sequence
Set the sequence of boot drives ( either floppy drive A: or hard
disk drive C: Primary Master) in which the WINBIOS attempts
to boot from after POST completes. The Optimal and Fail-Safe
dault settings are A: C:
Cache Memory
Enable or Disable the internal and/or L2 cache. The Optimal
default setting is Both. The Fail-Safe default setting is Disable.
Adapter Shadow Cacheable
Enable or Disable the cacheability of the shadowed adapter
ROM area. The Optimal and Fail-Safe default settings are
Disable.
System BIOS Shadow Cacheable
Enable or Disable the cacheability of the syetm, ROM BIOS in
the F0000h memory segment. This segment is always shad-
owed to RAM. The Optimal default setting is Enable. The Fail-
Safe default setting is Diasable.
Password Checking
Enables the passwaord check option every time the system
boots or the end user run setup. If Always is chosen, a user
password prompt appears every time the computer is turned on.
If Setup is chosen, the password prompt appears if WINBIOS is
executed. The Optimal and Fail-Safe default settingsare Dis-
able.