Table of Contents
Advertisement
3.14 Peripheral Device Installation
After controller jumpers setup, the mainboard can be mounted onto the
case. Then install the peripheral controller, display interface, and the disk
controller.
If the PCI-Bus device is to be installed in the system, any one of the four
PCI-Bus slots can be used no matter Slave or Master PCI-Bus device being
installed.
If the EISA-Bus drivers is to be installed in the system, only four Bus-
Master devices can be installed. EISA slot 1 or slot 5, slot 2, slot 3 and
slot 4.
After installing the peripheral controller, the user should check everything
again, and prepare to power-on the system.
3.15 Turbo / Deturbo by keyboard
press <Ctrl> + <Alt> + [-] : turn off turbo function.
press <Ctrl> + <Alt> + [+] : turn on turbo function.
S1642-001-01
19
Advertisement
Table of Contents
