Table of Contents
Advertisement
* Video
This category detects the type of adapter used for the primary system
monitor that must match your video display card monitor. Although
secondary monitors are supported, you do no have to select the type in
setup.
EGA/VGA
Enhanced Graphics Adapter/Video Graphics Array.
SVGA, or PGA monitor adapters.
CGA 40
Clolr Graphics Adapter, power up in 40 column mode.
CGA 80
Color graphics Adapter, power up in 80 column mode.
MONO
Monochrome
adapters.
* Halt On
The category determines whether the computer will stop if an error is
detected during power up.
No
errors
Whenever the BIOS has detected a non-fatal error, the
system will be stoped and you will be prompted.
All errors
The system boot will not be stopped for any errors that may
be
detected.
All, but keyboard The system boot will not stop for a keyboard error; it will stop
for all other errors.
All, but Diskette
The system boot will not stop for disk errors; it will stop for all
other
All, but Disk/Key
The system boot will not stop for a keyboard or disk error; it
will stop for all other errors
* Memory
The category is for display-only and it is determined by POST Power On
Self Test of the BIOS.
Base Memory
The POST of the BIOS will determine the amount of
base (or conventional) memory installed in the system.
The value of the base memory is typically 512K for
systems with 512K memory installed on the motherboard,
or 640K for systems with 640K or more memory installed
on the motherboard.
Extended Memory
The BIOS determines how much extended memory is
present during the POST. This is the amount of
memory located above 1MB in the CPU's memory
address map.
S1462-001-01
adapter,
includes
high
errors.
28
For EGA, VGA,
resolution
monochrome
Advertisement
Table of Contents
