TYAN TEMPEST II Manual page 61

23 Base 64K test passed. Going to set BIOS stack and to do
any setup before Interrup vector Init.
24 Setup required before Vector Init. complete. Interrupt vector
Init. about to begin.
25 Interrupt Vector Init. done. Going to read input of 8042 for
Turbo SW. and to clear password if POST diag SW ON.
26 Input port 8042 is read. Going to Init global data for Turbo
SW.
27 Global data Init. for Turbo SW is over. Any Init. before
setting video mode to be done next
28 Init. before setting video mode is complete. Going for
Mono mode and color mode setting.
2A Different BUSes init to start if present.
2B About to give control for any setup required before optional
Video ROM check.
2C Processing before vide ROM control is done. About to look
for option vide ROM and give control.
2D Optional video ROM control is done. About to give control
to do any processing after video ROM return control.
2E Return from processing after the video ROM control. If
EGA/VGA not found then do display memory R/W test.
2F EGA/VGA not found. Display memory W/W test about
to start..
30 Display memory R/W test passed. About to look for the
retrace checking.
31 Display memory R/W test or retrace checking failed.
About to do alternate Display memory R/W test.
32 Alternate Display memory R/W test passed. About to look
for the alternate display retrace checking.
34 Video display check over. Display mode to be set next.
37 Display mode set. Going to display the power on message.
38 Different BUSes Init. to start if present.
S1642-001-01 61