Advanced Setup - TYAN TEMPEST II Manual

Primary Master
Primary Slave
Select one of these hard disk drive Icons to configure the drive named in
the option. WINBIOS supports up to four IDE hard disk drives: the pri-
mary master, primary slave, secondary master and secondary slave. If the
hard disk drive is an IDE drive, select DETECT PRIMARY or DETECT
SLAVE from the Utility Setup Option Section of the WINBIOS Setup
Main Menu to have WINBIOS automatically detect the IDE drive param-
eters and report them to this screen.
The SCSI must be selected if SCSI Disk Drive was connected.
You can also enter the hard disk drive parameters. Hard disk type 47 is the
user-definable drive type. The drive parameters are: Type, Cylinders, Heads,
Write precompensation, Landing Zone, Sectors and Capacity.
Floppy Drive A:
Floppy Drive B:
Move the cursor to these fields via up and down arrow key and select the
floppy type. The setting are 360 KB 5 1/4 inch, 1.2MB 5 1/4 inch, 720MB
3 1/2 inch,and 1.44MB 3 1/2 inch.

5.2 Advanced Setup

The WINBIOS Setup options decribed in this section are selected by
choosing the Advanced Setup Icon from the WINBIOS Setup Main
Manu.
Typematic Rate (Chars/Sec)
Set the rate at which characters on the screen repeat when a key is
pressed and held down. The Optimal setting is 30 characters per second.
The Fail-Safe default setting is disabled.
System Keyboard
Specify if error messages are displayed if a keyboard is not attacted. This
option permits you to configure workstations with no keyboards. The
Optimal and Fail-Safe defalt settings are Present.
S1642-001-01 41