TYAN TEMPEST II Manual page 35

*1st Available IRQ#
*2nd Available IRQ#
*3rd Available IRQ#
*4th Available IRQ#
Select four Available IRQs assigned to PCI slots INT
*PCI IRQ Actived By:
Select the PCI IRQ Active scheme either LEVEL or EDAGE. Default
is LEVEL.
*PCI IDE IRQ Map To:
Select the IDE IRQ Map to ISA IRQ#
*Primary IDE INT#
Select the Primary IDE disk controller uses the PCI INT#.
*Secondary IDE INT#
Select the Secondary IDE Disk Controller uses the PCI INT#
* If you use FOUR NCR 810/825 SCSI-PCI cards in the system, you
need to assign IRQ 10 for the card that is in slot 1. In the same way,
assign IRQ 11 for the card in slot 2, assign IRQ12 for the card in slot
3, and assign IRQ 9 for the card in slot 4. However, no matter which
slot the SCSI-PCI card was inserted, you should set INT A to enabled
SCSI-PCI card itself. The system will automatically assign those IRQs to
INTA, INTB, INTC and INTD.
S1642-001-01 35