TYAN TEMPEST II Manual page 58

4 1 Initialize floppy
and controller
4 2 initialize hard
and controller
4 3 detect and initialize
serial and parallel
ports
4 4 r e s e r v e d
4 5 detect and initialize
math co-processor
4 6 r e s e r v e d
4 7 reservved
4 8 - 4 D r e s e r v e d
4 E Manufacturing
Loop or display
m e s s a g e s
4 F Security check
5 0 Write CMOS
5 1 PRE-boot enable
5 2 Initialize Option
ROM's
5 3 Initialize Time
6 0 Setup Virus Protect
6 1 Set Boot Speed
6 2 Setup NunLock
6 3 Boot Attempt
B 0 S p u r i o u s
B 1 Unclaimed NMI
E1-EF Setup Pages
S1462-001-01
drive Initialize floppy disk drive and and drives
drive Initialize hard drive and any drives
Initialize any serial and parallel portss (also
g a m e p o r t )
Initialize math
POST Reboot if manufacturing POST Loop pin is
set. Otherwise display any messages (i.e.
any non fatal errors that were detected
durning POST) and enter setup
Ask password
Write all CMOS values back to RAM and
clear screen
Enable parity checker.
cache before
Initialize any option ROM's present for
C8000h to EFFFFh.
enabped, will initialize from C8000h to
F7FFFh.
Value Initialzie time value in 40h: BIOS area.
Setup Virus protect according to setup
set system speed for boot
setup NumLock
Set low stack.
If interrupt occurs in protected mode.
fi unmasked NMI occurs, display Press F1
to disable NMI , F2 Reboot
E1-Page 1, E2-Page 2, ect.
58
co-processor
security (optional)
Enable NMI, Enable
boot.
When FSCAN option is
status according to Setup
Boot via INT 19h