Configuring Your Library Using The Operator Control Panel; Preparing The Host; Restoring Factory Default Settings Using The Web User Interface" On Page; Logging Out Of The Web User Interface - Dell PowerVault TL2000 User Manual

For information on running the diagnostic, refer to "Service Library: Key Path
Diagnostics" on page 5-61.
Restoring Factory Default Settings using the Web User Interface
If you would like to erase your current configuration and restore factory default
settings, do so by selecting Restore Factory Defaults in the Configure Library →
Save/Restore menu. See "Configure Library: Save/Restore Configuration" on page
5-56.
The factory default settings are listed in Table 5-4 on page 5-28.

Logging out of the Web User Interface

To log out of the Web User Interface, click Logout in the upper right corner of the
current screen.
Important: If you click the X in the upper right corner of your internet browser

Configuring Your Library using the Operator Control Panel

If you choose to use the Operator Control Panel for configuring your library, go to
"Configure Menu" on page 5-18 for information on configuring the following
items:
v Logical Libraries
v Library Settings
v Drive(s)
v Network
v Set Access PIN
v Set Date and Time
v Path Failover
To complete the configuration of your library, the following items will have to be
accessed from the Web User Interface:
v Encryption (if purchased) (see "Configure Library: Encryption" on page 5-47)
v User Access Information (see "Configure Library: User Access" on page 5-52)
v Logs and Traces (see "Configure Library: Logs & Traces" on page 5-54)
v Event Notification Information (see "Configure Library: Email Notification" on
v Key Path Diagnostic (if Encryption was purchased) (see "Service Library: Key
v Updating Firmware (see "Service Library: Upgrade Firmware" on page 5-62)

Preparing the Host

Follow these general guidelines:
1. Make sure that your backup application supports the SCSI, SAS, or Fibre
2. If the host server is connected to a network, check with the system
window, you will not log out of the Web User Interface.
page 5-55)
Path Diagnostics" on page 5-61)
Channel host bus adapter (HBA).
administrator before turning host power OFF.
Chapter 4. Installation and Configuration
4-31