Control Panel; Removing Control Panel Board-8 Hdd System - Dell Storage NX3330 Owner's Manual

Steps
1 Use the hooks on the chassis as guides to align the HDD backplane.
2 Lower the HDD backplane until the release tabs snap into place.
3 Connect the SAS/SATA/SSD data, signal, and power cable(s) to the backplane.
Next steps
1 Install the HDDs in their original locations.
2 Complete the tasks listed in the After working inside your system section in this document.
Related links
Safety instructions
Before working inside your system
After working inside your system

Control panel

The control panel contains the power button, the diagnostic indicators, and the front USB ports.
Removing control panel board–8 HDD system
Prerequisites
1 Ensure that you read the Safety instructions section in this document.
2 Follow the procedure listed in the Before working inside your system section in this document.
3 Keep the #2 Philips screwdriver ready.
CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple
repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage
due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that are
shipped with your product.
CAUTION: The display module connector is a ZIF (zero insertion force) connector. Ensure that the locking tab on the connector
is released before removal and insertion. The locking tab must be engaged after insertion.
Steps
1 Disconnect the control panel and display module cables from the control panel board.
2 Using a #2 Phillips screwdriver, remove the two screws that secure the control panel board to the chassis.
3 Slide the control panel board toward the back and out of the system.
Installing and removing system components 97