Installing The Replacement Library Enclosure; Left Magazines Pulled Out Of A 4U Library - Dell PowerVault TL2000 User Manual

Figure 10-23. Left magazines pulled out of a 4U library (facing front of library)
2. Insert the cartridge magazines removed from the defective library into the same
3. Insert the cartridge magazines removed from the replacement library enclosure
4. Wait for inventory of the magazines to complete.

Installing the Replacement Library Enclosure

Refer to the appropriate procedure in this section (rack or desktop) for installing
the replacement library enclosure.
Note: If you are shipping the replacement library enclosure to a remote location,
Rack Installation:
1. Remove the mounting brackets ( 1 in Figure 10-24 on page 10-26) and anchors
positions in the replacement library enclosure.
into the same positions in the defective libraryto return to Dell.
a. If inventory is successful:
1) The replacement library enclosure will complete with the
Ready/Activity LED ( 1 in Figure 10-20 on page 10-22) ON.
2) Power OFF the replacement library enclosure.
3) Proceed to "Swapping Power Supplies" on page 10-19.
b. If inventory is not successful:
1) The Error LED ( 4 in Figure 10-20 on page 10-22) will turn ON.
2) Power OFF the enclosure.
3) Contact Technical Support for further instructions.
install the shipping lock and label before shipment.
( 2 ) from each side of the defective library and install them on the
replacement library enclosure.
Chapter 10. Check, Adjust, Remove, and Replace
10-25