Dell PowerVault TL2000 User Manual page 251

Table C-2. LTO Tape Drive Sense Data (continued)
Byte 7
12-13 Additional Sense Code (ASC) -
Additional Sense Code Qualifier (ASCQ) (Continued)
Byte 12 Byte 13
ASC ASCQ
41 00 - Data path failure
43 00 - Message Error - A message could not be sent or received due to excessive
44 00 - Internal target failure - A hardware failure has been detected in the drive
45 00 - Select/Reset Failure - An attempt to reselect an initiator in order to
48 00 - Initiator detected error message received
49 00 - Invalid message error
4A 00 - Command phase error
4B 00 - Data Phase Error - A command could not be completed because too many
4E 00 - Overlapped Commands - An initiator selected the drive even though it
50 00 - Write Append Error - A write type command failed because the point at
51 00 - Erase failure - An Erase command failed to erase the required area on the
52 00 - Cartridge fault - A command could not be completed due to a fault in the
53 00 - Media Load/Eject Failed - (Sense Key 03) An attempt to load or eject
53 00 - Media Load/Eject Failed - (Sense Key 04) An attempt to load or eject
53 02 - Media Removal Prevented - An Unload command has failed to eject the
5A 01 - Operator medium removal request
5D 00 - Failure Prediction Threshold - Failure Prediction thresholds have been
5D FF - Failure Prediction False - A Mode Select command has been used to test
82 82 - Drive requires cleaning - The drive has detected that a cleaning operation
82 83 - Bad Code Detected - The data transferred to the drive during a
6 5
transmission errors
that has caused the command to fail
complete the command has failed
parity errors occurred during the Data phase
already had a command outstanding in the drive
which to append data was unreadable
media
tape cartridge
the cartridge failed due to a problem with the cartridge.
the cartridge failed due to a problem with the drive
cartridge because media removal has been prevented
exceeded indicating that a failure may occur soon
for Failure Prediction system.
is required to maintain good operation
firmware upgrade is corrupt or incompatible with drive hardware
Bit Address or Name
4 3 2 1
Appendix C. Sense Data
0
C-9