3. Using the screws for your rack type (round holes or square holes) and a #2
Figure 4-6. Rear view of a rack showing the narrow part of the rail
4. Using the Torx wrench included in your shipment, remove the screws (
Figure 4-7. 2U library side screws to remove
5. Install the library rack anchors ( 2 ) as shown in Figure 4-8 on page 4-9 on
4-8
Dell PowerVault TL2000 Tape Library and TL4000 Tape Library User's Guide
Phillips screwdriver and ensuring that the flange on each rail points toward the
other to form a shelf, secure one rail to each side of the rack in your chosen
rack location. Secure both the front and back of each rail to the rack. The
narrow end of each rail goes to the rear of the rack. The rails extend to fit a
variety of rack depths. Each rail requires 2U of rack space ( 1 in Figure 4-6).
shown in Figure 4-7. Screw locations on the 4U library are similar.
each side of your library using the longest counter-sunk screws included in the
rack kit.
1
1
1
) as