Factory Default Settings - Dell PowerVault TL2000 User Manual

v Restore Passwords - This menu item restores the factory default RMU Admin
v Restore all - This menu item restores all factory default settings (refer to
v Restore Library Config - This menu item restores your saved library
v Save Library Config - This menu item saves your library configuration to a USB
Note: Configuration files saved with one version of library firmware may not be
Important: Restoring factory defaults will wipe out all the previous configuration
data. Factory defaults must be restored when the library drive is changed from a
LTO half height to full height configuration, in order for the library to correct the
element addressing and drive numbering. If a new drive is added to the library
configuration, a restore factory default is not required.
Table 5-4. Factory Default Settings
Restored Item
Autoclean
Logical Libraries
Active Slots
I/O Station
Encryption
Ethernet Setting
DHCP
Network IP Mode
Bar Code Label Length Reported to
Host
SNMP
Email Notifications
User Access
Admin
5-28
Dell PowerVault TL2000 Tape Library and TL4000 Tape Library User's Guide
user access password.
Table 5-4).
configuration from a USB device. If you have more than one saved configuration
file (.dbb) on your USB device, press Select, then use the up and down keys to
move between the different files. When the correct configuration file is
displayed, press Select again.
device.
Note: Ensure the USB device is formatted for FAT12, FAT16, or FAT32 and does
not use autorun files.
compatible with other versions of firmware. It is recommended to save a
configuration file each time the library firmware is upgraded. Restore the
library using a configuration file that was saved with the same version of
firmware currently installed in the library.
Default Setting*
Disabled
1
Maximum number of slots in library
minus I/O Station
Enabled
None
Auto
Enabled
IPv4 Only
8
Disabled
None
secure
Comments
2U library has 1-slot I/O Station.4U
library has 3-slot I/O Station.
License Key is protected, if
previously entered.
Note: DNS server addresses, if
available, will be automatically
assigned. If the DHCP server does
not find any DNS server, the DNS
fields will be set to "0.0.0.0".
Restore from Operator Control Panel
or Web User Interface
(default)