Dell PowerVault TL2000 User Manual page 249

Table C-2. LTO Tape Drive Sense Data (continued)
Byte 7
12-13 Additional Sense Code (ASC)
Additional Sense Code Qualifier (ASCQ)
Byte 12 Byte 13
ASC ASCQ
00 00 - No additional sense - The flags in the sense data indicate the reason for
00 01 - Filemark detected - A Read or Space command terminated early due to an FM
00 02 - EOM - A Write or Write File Marks command failed because the physical
00 04 - BOM - A space command ended at Beginning of Tape
00 05 - EOD - Read or Space command terminated early
00 16 - Operation in Progress
04 00 - Cause not reportable - A cartridge is present in the drive, but it is in the
04 01 - Becoming Ready - A media access command was received during a
04 02 - Initializing Command Required - A cartridge is present in the drive, but is not
04 03 - Manual Intervention Required - A cartridge is present in the drive but could
04 10 - Logical unit not ready, auxiliary memory not accessible
04 12 - Logical unit not ready, offline
08 01 - Logical unit communication failure
09 00 - Track following error (servo)
0C 00 - Write Error - A Write operation has failed. This is probably due to bad
11 00 - Unrecovered Read Error - A Read operation failed. This is probably due
11 12 - Auxiliary memory read error. The drive reported that it is unable to read the
14 00 - Recorded Entity Not Found - A space or Locate command failed because
14 03 - End Of Data not found - A Read type operation failed because a format
14 10 - Not Ready - Auxiliary memory not accessible. The drive is not able to become
17 01 - Recovered data with retries
1A 00 - Parameter list length error - The amount of parameter data sent is incorrect
20 00 - Invalid Command Operation Code - The Operation Code in the command
24 00 - Invalid field in CDB - An invalid field has been detected in a
25 00 - LUN not supported - The command was addressed to a non-existent
26 00 - Invalid Field in Parameter List - An invalid field has been detected in the
6 5
the command failure
The FM flag is set.
end of tape was encountered, or a Read or Space command encountered EOM
The EOM flag is set
The EOM bit is also set
because End of Data was encountered
process of being unloaded
front panel initiated load or an immediate reported load command
logically loaded. A Load command is required
not be loaded or unloaded without manual intervention
media, but may be hardware related
to bad media, but may be hardware related
Auxiliary Memory in a WORM cartridge.
a format violation prevented the target from being found.
violation related to a missing EOD data set
ready because it is unable to access the Auxiliary Memory in a WORM cartridge.
was not a valid Operation Code
Command Descriptor Block
logical unit number
data sent during the data phase
Bit Address or Name
4 3 2 1
Appendix C. Sense Data
0
C-7