Bottom Position) On Back Panel Of A 4U Library - Dell PowerVault TL2000 User Manual

7
6
Figure 10-6. Drive sled components (full-high fibre drive in top position, half-high SCSI drive in middle position,
half-high SAS drive in bottom position) on back panel of a 4U library
1
SCSI cable
2
SAS cable
3
SCSI terminator
4
Fibre Channel cable
5
Ethernet cable
6
Power cords
7
Drive sled blue captive thumbscrews
8
Black pull-out tab
9
Drive sled
10
Drive sled handle
5. If present, remove the conductive tape from the drive sled (refer to Figure 10-9
6. Loosen the blue captive thumbscrews ( 7 in Figure 10-6) on the drive sled.
7. Pull straight back on the drive sled handle ( 10 ) to remove it from the library
8. If you are replacing the tape drive sled, proceed to Installing a Tape Drive Sled
9
10
1
on page 10-8).
(see Figure 10-7 on page 10-6).
for instructions. If you are not replacing the tape drive sled immediately, you
will need to perform the following procedures:
a. Install a drive cover plate to protect your library from dust and debris.
b. To remove the "Missing drive" indicators on the Operator Control Panel
(Attention LED) and the Web User Interface (System Status screen), modify
or resubmit logical library setting (Operator Control Panel: Configure →
Logical Libraries or Web User Interface: Configure Library → Logical
Libraries).
4
3 2 5
8
Chapter 10. Check, Adjust, Remove, and Replace
7
10-5