Table of Contents
Advertisement
12
At the Overwrite Existing Files menu, select Yes if you are
prompted to overwrite the RPCNET.CFG file. Select No for
other prompts.
13
At the Installation for Select Files group done message, press
Esc twice.
14
At the Exit Installation screen, select Yes.
15
At the next two screens, press Esc.
16
At the Exit Install (for NW 4.11) or nwconfig (for NW 5.0)
screen, select Yes.
Installing the Adaptec CI/O Management
Software on Novell NetWare Servers
Note:
Before you start the Adaptec CI/O Management
Software, be sure the TIRPC communications module is
installed (see the following section). Also, ensure that
communication with the server via the network is already
established. (See the documentation provided with your
TCP/IP software for instructions on establishing
communications.)
For communications supported over TCP/IP, the following steps
must be completed:
The tcpip.nlm must be loaded and the IP protocol must be
bound to a valid IP address.
The IP protocol generally must be bound to an ethernet frame
type, ETHERNET_II, which must be specified when loading
the LAN driver. A LAN driver can be loaded multiple times
for different ethernet frame types.
Follow these steps to install Adaptec CI/O Management Software
from a DOS-mounted CD-ROM drive for Novell NetWare v4.11 and
Novell NetWare v5.0:
Installing CI/O Software
2-19
Advertisement
Table of Contents
