Adaptec 133U2 - AAA RAID Controller User Manual page 147

Configuration Settings
Note that putting an asterisk anywhere in the names makes all the
other names meaningless. The specification:
AccessibleDrivers = AIC, *
would cause all drivers to be accessible, not just AIC drivers.
Up to 100 drivers may be specified, and the maximum length of the
string of driver names is 255 characters. The names specified in the
AccessibleDrivers statement may differ on different operating
system platforms.
Drivers are only checked for accessibility when a host adapter is
discovered; if a host adapter already exists in the device database
then this option has no effect upon that host adapter or upon
subsequently discovered devices on the host adapter. Therefore, the
device database should usually be cleared after changing this
option.
[ARRAYOPERATIONS]
RecreatePriority=
This variable specifies the priority of the automatic Re-create
operation. Valid values are Low, Medium, or High. The default is
Medium.
VerifyIfDirty=
This variable specifies whether you want to start the Verify
operation if the array is dirty (meaning that the array was not shut
down properly). Valid values are Yes or No. The default value is Yes.
[SYSTEM]
PauseEnabled=
This variable specifies whether the Pause I/O capability is enabled
or disabled. Valid values are Yes and No.
ServerLogSizeInMegabytes=
This variable is used to limit the size of the Server Log database file.
The Server Log database will be truncated if it grows beyond the
size specified by the parameter. The size can be specified in
increments of 1 MByte, up to a maximum of 10 MBytes.
A-7