Follow these steps to rescan the system:
1
Click
to open the Storage Configuration window.
2
Click
on the Storage Configuration window toolbar.
3
At the prompt, confirm that you want to rescan the server.
When the rescan is complete, any hardware changes are
reflected in the icons in the Storage Configuration window.
Note:
You cannot use the Rescan command to recognize an
entire array that was transferred from another system. You
must reboot the system before it recognizes the transferred
array. However, if you remove a disk that is an array
member, replace it with another disk, and issue a Rescan
command, Adaptec CI/O Management Software will detect
that the new disk is no longer an array member.
Viewing Array and Device Information
6-7