Adaptec 133U2 - AAA RAID Controller User Manual page 158

Adaptec CI/O Management Software User's Guide
"SCSI error" event is posted because the SAF-TE enclosure
does not support some of the SAF-TE-interface commands.
This situation does not require any intervention by the user.
7
For each change in the status of the power supplies connected
to the enclosure, the following events indicating the new
status may be posted:
a
PowerSupply #power_supply is operational and OFF
[SAF-TE unique address]
b
PowerSupply #power_supply is operational and ON
[SAF-TE unique address]
c
PowerSupply #power_supply is malfunctioning and OFF
[SAF-TE unique address]
d
PowerSupply #power_supply is malfunctioning but ON
[SAF-TE unique address]
e
PowerSupply #power_supply is present [SAF-TE unique
address]
f
PowerSupply #power_supply is not present[SAF-TE unique
address]
g
PowerSupply #power_supply is in unknown state[SAF-TE
unique address]
8
For each change in the status of the door lock of the enclosure,
the following events indicating the new status may be posted:
a
Door is locked [SAF-TE unique address]
b
Door is unlocked [SAF-TE unique address]
c
Speaker is present [SAF-TE unique address]
d
Speaker is not present [SAF-TE unique address]
9
CI/O will set LED states of devices located inside enclosures in
the following cases:
– Drive failed (failed drive is identified)
– Predicted Fault (identifies the drive for which PDF event
was received)
– Unconfigured drive (identifies an unconfigured drive)
B-8