Setting A Slot-Level Ip Address; Figure 15 Blade Tab - Brocade Communications Systems 8 Administrator's Manual

3. Select the Enable Blade check box for each blade you want to enable.
4. Click Apply.

Setting a slot-level IP address

Use the following procedure to set an IP address.
1. Open the Switch Administration window as described in
2. Select the Blade tab.
3. Click Set IP address.
4. Select a slot number from the list.
5. Enter the IP address, subnet mask, and Gateway IP address.
6. Select a type from the list.
Web Tools Administrator's Guide
53-1001772-01
DRAFT: BROCADE CONFIDENTIAL
The Firmware Version columns display the firmware loaded onto each blade. A blade can have
more than one firmware image loaded onto it. The Enable Blade column in the Blade tab pane
indicates whether the blade is enabled.
FIGURE 15
Blade tab
Clear the check box to disable the blade. You cannot enable or disable the CP blades.
window" on page 35.
Blade management
"Opening the Switch Administration
3
39