Quality Of Service Configuration; Adding A Cee Map - Brocade Communications Systems 8 Administrator's Manual

Supporting fabric os v6.4.0
Hide thumbs Also See for 8:
Table of Contents

Advertisement

19

Quality of Service configuration

Quality of Service configuration
As a general concept, Quality of Service (QoS) is a mechanism for classifying and scheduling data
traffic based on priority settings. QoS can be used to control traffic congestion, allocate bandwidth,
and carry data traffic with different characteristics over a common interface.
The following two configuration options are available:

Adding a CEE map

A CEE map defines priority and priority group tables that support Enhanced Transmission Selection
(ETS). ETS allows bandwidth to be allocated based on priority settings through an exchange of
priority group tables.
Use the following procedure to add a CEE map.
1. Select the CEE tab on the Switch Administration panel.
2. Select the QoS tab.
3. Select the CEE Map tab.
4. Click Add.
5. Enter a name for the CEE map in the Name field.
6. Enter a precedence value in the Precedence field.
7.
258
DRAFT: BROCADE CONFIDENTIAL
You can create a CEE map. A CEE map defines priority and priority group tables that support
Enhanced Transmission Selection (ETS). ETS allows allocation of bandwidth to different traffic
classes. CEE maps also allow you to enable Priority Flow Control (PFC).
You can create a traffic class map. A traffic class map can be used to map a specific class of
traffic to a specific Class of Service (CoS).
The CEE Map Configuration dialog box displays.
The value is specified as a number. The allowable range is 1 to 100. The default is 1.
The precedence value controls QoS scheduling policies. If different CEE maps have conflicting
policies, the scheduler gives precedence to the CEE map with the highest precedence value
(the highest number).
When the CEE Map Configuration dialog box displays, the default values shown in the Priority
Group Map match the IEEE 802.1Q recommendation for systems supporting eight traffic
classes. The Priority Group Map displays the Layer 2 Cos values mapped to Priority Group ID
(PGID). PGID values are in the form
Priority values run from 0 (highest priority) to 7 (lowest priority). Note that this is contrary to the
CoS values, which run from 7 (highest priority) to 0 (lowest priority).
Create a new priority group by clicking Add next to the Priority Group table.
An entry is added to the Priority Group table.
NOTE
When you add an entry, a PGID is automatically assigned. The PGID is an integer from 0 to 7.
The first added entry is given a PGID of 0, and the PGID increments by one for each additional
added entry until a PGID of 7 is reached.
. A policy value of 15 indicates
<policy>.<priority>
Web Tools Administrator's Guide
53-1001772-01

Advertisement

Table of Contents
loading

Table of Contents