Step 2: Camera Selection; Operating A Ptz Camera; Table 4-3 Operations For A Ptz Camera - Honeywell UltraKey Touch HJC4000 Installation And User Manual

Installing UltraKey Touch with PTZ

Step 2: Camera Selection

Operating a PTZ Camera

You want to...
Control a PTZ camera
Zoom in/out
Adjust the iris
Manually focus
Program a preset
Run a preset
60
2. See the PTZ configuration menu tree (
page 52). Select Standalone Settings, press Ent, and
rotate the slider to enter PTZ Settings, or press PTZ.
You can set the PTZ Name, Address, and Protocol.
Note The UltraKey Touch supports five PTZ Protocols: Pelco P, Pelco D, Diamond,
VCL, and Intellibus. You must set the PTZ's Protocol to be consistant with the
controlled PTZ.
1. Return to the main menu of standalone mode after finishing keyboard setup
2. Enter a camera number (1–128) + Camera, or Camera + number + Ent, or number
+ Ent to select a camera for controlling.
Table 4-3 Operations for a PTZ Camera
Do this...
Use the joystick to control (pan and tilt) the camera. Move the joystick up/down for
tilt functions and left/right for pan functions.
Rotate the joystick clockwise/counter-clockwise.
Press Iris (+) and Iris (–).
Press Focus (+) or Focus (–).
Press View + number + Set.
Press View + number + Ent, or number + View.
PTZ call for Diamond Protocol
The PTZ call is used in Diamond protocol and Intellibus protocol to control certain features
of the PTZ camera.
For Diamond protocol, press PTZ call and the following figures are displayed in sequence
by rotating the slider. Press Ent to select. Press Clr to exit from the Dome OSD display.
1. PTZ - Auto Iris
Press Ent to send auto iris command.
Figure 4-1 on
Standalone Set:
PTZ
<Cam001>
Auto Iris