Installing And Configuring A Serial Connection; Step 1: Connect To The Ultrakey Touch Serial Port; Figure 4-1 Ptz Configuration Menu Tree; Table 4-1 Serial Port Com1 Pin Assignments - Honeywell UltraKey Touch HJC4000 Installation And User Manual

Installing UltraKey Touch with PTZ
Standalone
Settings
PTZ
PTZ Settings
Protocol /
Address / Name

Installing and Configuring a Serial Connection

Step 1: Connect to the UltraKey Touch Serial Port

52
Figure 4-1 PTZ Configuration Menu Tree
System
Configuration
Serial Port
DVR COM1 (RS485)
Serial Settings
Baud Rate
Parity
Note For a list of accessories see
connections see
18.
Note COM1 (RS485) are configured using the System Configuration menu. See
Table 4-1 below. For connection between Ultrakey Touch and PTZ, refer to
Figure 4-2. Certain settings should be done before using the direct control of
a PTZ with Ultrakey Touch.
Table 4-1 Serial Port COM1 Pin Assignments
Serial Port Type
COM1 RS485
Show Net Infor
IP Address
Data Bit Gateway
Stop Bit
Shipping Checklist
UltraKey Touch Port Connections and Descriptions
Pin Signal
1 T/R +
2 T/R –
Network
Manual Settings DHCP
NetMask
DNS
on page 17 and for port
on page