Figure 4-2 Rs485 Serial Port Connection Ptz By Rj45 Box; Table 4-2 Rj45 Box Pin Assignments - Honeywell UltraKey Touch HJC4000 Installation And User Manual

Document 800-06554 Rev C
02/11
RS485 Serial Port Connecting to a PTZ using the RJ45 Box:
1. Select the applicable adapter plug and insert it into the AC adapter. Push to click it
into place. See Figure
2. Connect an RJ45 network cable from the RJ45 Box port to the controller serial port.
3. Connect the pin (RS485+, RS485–) of the RJ45 Box to a PTZ using an appropriate
wire.
Note To setup Cascade Linkage for UltraKey Touch, see
for Cascade Linkage (Additional)
Figure 4-2 RS485 Serial Port Connection PTZ by RJ45 Box
RJ45 box
Table 4-2 RJ45 Box Pin Assignments
Pin Signal
1 RS485+
2 RS485–
4 RS232 RXD
5 GND
6 RS232 TXD
UltraKey Touch Installation and User Guide
4-2.
on page 37.
RS485
5 4
6 3
7 2
8 1
Network
cable
Serial Port (RS485) Network Port
Master
UltraKey Touch
Keyboard Configuration
NETWORK
Network
Network
cable
cable
Network Port
Slave 1
53