When Using The Postscript 3 Printer Driver; Form Feed; Banner Page; Printing After Resetting The Printer - Ricoh SP 5200S Operating Instructions Manual

When Using the PostScript 3 Printer Driver

This section explains how to set up a Windows computer used as a NetWare client when using the
PostScript 3 printer driver.
• In an IPv6 environment, Netware servers cannot be used.
Follow the procedure below to set up the PostScript 3 printer driver.
1. In the [Printers] or [Printers and Faxes] window, open the printer properties.
2. Click the [Device Settings] tab.
3. Select [No] on the [Send CTRL-D Before Each Job:] and [Send CTRL-D After Each Job:],
and then click [Apply].
4. Click [OK] to close the printer properties dialog box.

Form Feed

Do not use NetWare to configure form feed. Form feed is controlled by the printer driver on Windows. If
NetWare form feed is configured, the printer may not print properly.
Follow the procedure below to disable form feed according to the operating system used:
Clear the [Form feed] check box on the [NetWare Settings] tab in the printer properties dialog box.

Banner Page

Do not use NetWare to configure banner page.
Follow the procedure below to disable banner page according to the operating system used:
Clear the [Enable banner] check box on the [NetWare Settings] tab in the printer properties dialog box.

Printing after Resetting the Printer

Printer to print server connection requires 30 - 40 seconds to resume after the printer is reset. During this
period, jobs may be accepted (depending on NetWare specifications) but not printed.
To print after resetting the printer as the remote printer, check on the print server that the remote printer is
disconnected, or wait for two minutes before trying to print.
Using as a NetWare Print Server/Remote Printer
1
45