Drive Carrier Module Faults; Blank Drive Carriers; Dealing With Hardware Faults; Table 9. Drive Fault Led Functions - Intel SSR212CC User Manual

Drive Carrier Module Faults

Disk drive status is monitored by an amber LED mounted on the front of each drive
carrier module, under electro static interference (ESI) processor control. The LED
conditions are defined in the following table.

Table 9. Drive Fault LED Functions

No drive fitted
Drive Fault bit set
NOTE: The Drive Status LED may be off for a length of time during power up.

Blank Drive Carriers

Important: Blank drive carriers must be fitted in all unused drive bays to maintain a balanced
airflow.

Dealing with Hardware Faults

Ensure that you have obtained a replacement module of the same type before removing
any faulty module.
Warning: If the Intel® Storage System SSR212CC sub-system is powered up and you remove any
module, replace it immediately. If the subsystem is used with modules or module blanks
missing for more than a few minutes, the storage system can overheat, causing power
failure and data loss. Such use will invalidate the warranty.
•
Replace a faulty drive with a drive of the same type and equal or greater capacity.
•
All drive bays must be fitted with a drive carrier or a blank drive carrier in order to
maintain a balanced airflow.
•
All power supply module(s), electronics modules and/or blank plates must be in place
for the air to flow correctly throughout the storage system.
Intel® Storage System SSR212CC User Guide
State Amber LED
Off
Continuous
Troubleshooting and Problem Solving
111