System Storage And Peripheral Drive Bays Overview; 2.5" Hard Disk Drive Support; Figure 10. 2.5" Hard Drive Bay - 24-Drive Configuration; Figure 11. 2.5" Drive Tray Assembly - Intel JBOD 2000 Hardware Manual

Intel® Storage Server System JBOD 2000 Family Hardware Guide
3.

System Storage and Peripheral Drive Bays Overview

The Intel ® Storage Server System JBOD2000 product family supports the following storage
device options:
Hot-swap 2.5" hard disk drives

Hot-swap 3.5" hard disk drives

3.1

2.5" Hard Disk Drive Support

The server is available in 2.5" hard disk configurations of 24 drives as illustrated below.
The drive bay can support either SATA or SAS hard disk drives. Mixing of drive types within a
common hot-swap backplane is not supported. Systems with multiple hot-swap backplanes can
support different drive type configurations as long as the drives attached to a common
backplane are the same and the installed controller attached to the given backplane can support
the drive type. Hard disk drive type is dependent on the type of host bus controller used, SATA
only or SAS.
Each 2.5" hard disk drive is mounted to a drive tray, allowing for hot-swap extraction and
insertion. Drive trays have a latching mechanism that is used to extract and insert the drives
from the chassis, and lock the tray in place.
Revision 1.42
Figure 10. 2.5" Hard Drive Bay – 24-Drive Configuration

Figure 11. 2.5" Drive Tray Assembly

System Storage and Peripheral Drive Bays Overview
11