Configuring Static Routes - NETGEAR FVX538v2 - ProSafe VPN Firewall Dual WAN Reference Manual

ProSafe VPN Firewall 200 FVX538 Reference Manual
• port. Specifies the port number that the LDAP server is using. Leave this field blank for
the default port.
4. In the Advanced Settings section, select Enable DNS Proxy if you want to enabled the DNS
proxy, which is the default setting. The DHCP server will provide the VPN firewall's LAN IP
address as the DNS server for address name resolution. If this box is unchecked, the DHCP
server will provide the ISP's DNS server IP addresses. The VPN firewall will still service
DNS requests sent to its LAN IP address unless you disable DNS Proxy in the VPN firewall's
settings (see "Attack Checks" on page
5. Click Apply to save your settings or click Reset to discard any changes and revert to the
previous configuration. The DMZ LED next to LAN port 8 (see
Rear Panels" on page
To define the DMZ WAN Rules and LAN DMZ Rules, see
page 4-12 and "Configuring LAN DMZ Rules" on page

Configuring Static Routes

Static Routes provide additional routing information to your VPN firewall. Under normal
circumstances, the VPN firewall has adequate routing information after it has been configured for
Internet access, and you do not need to configure additional static routes. You should configure
static routes only for unusual cases such as multiple firewalls or multiple IP subnets located on
your network.
To add or edit a static route:
1. Select Network Configuration from the main menu and Routing from the submenu. The
Routing screen will display.
Figure 3-6
3-14
4-20).
1-6) will light up indicating that the DMZ port has been enabled.
v1.0, January 2010
"VPN Firewall Front and
"Configuring DMZ WAN Rules" on
4-13, respectively.
LAN Configuration