Restoring The Default Configuration And Password; Problems With Date And Time - NETGEAR FVX538v2 - ProSafe VPN Firewall Dual WAN Reference Manual

– If your ISP assigned a host name to your PC, enter that host name as the Account Name on
the WAN1 ISP Settings or WAN2 ISP Settings screen (see
– Your ISP could be rejecting the Ethernet MAC addresses of all but one of your PCs. Many
broadband ISPs restrict access by only allowing traffic from the MAC address of your
broadband modem, but some ISPs additionally restrict access to the MAC address of a
single PC connected to that modem. If this is the case, you must configure your VPN
firewall to "clone" or "spoof" the MAC address from the authorized PC. You can do this
on the WAN1 Advanced Options or WAN2 Advanced Options screen (see
page 2-16).

Restoring the Default Configuration and Password

This section explains how to restore the factory default configuration settings, changing the VPN
firewall's administration password to password and the IP address to 192.168.1.1. You can erase
the current configuration and restore factory defaults in two ways:
• Restore the VPN firewall to factory default settings from the Settings Backup and Firmware
Upgrade screen (see
• Use the reset button on the rear panel of the VPN firewall. Use this method for cases when the
administration password or IP address is not known.
To restore the factory default configuration settings without knowing the administration password
or IP address, you must use the reset button on the rear panel of the VPN firewall.
To restore the factory defaults:
1. Press and hold the reset button until the Test LED turns on and begins to blink (about 10
seconds).
2. Release the reset button and wait for the VPN firewall to reboot.

Problems with Date and Time

The Time Zone screen (select Administration from the main and Time Zone from the submenu)
displays the current date and time of day. The VPN firewall uses the Network Time Protocol
(NTP) to obtain the current time from one of several Network Time Servers on the Internet. Each
entry in the log is stamped with the date and time of day.
Troubleshooting
ProSafe VPN Firewall 200 FVX538 Reference Manual
"Reverting to Factory Default Settings" on page
v1.0, January 2010
Figure 2-1 on page 2-3).
Figure 2-7 on
6-20).
7-7