NETGEAR FVX538v2 - ProSafe VPN Firewall Dual WAN Reference Manual page 141

d. Check the Connect using radio button and select Secure Gateway Tunnel from the pull-
down menu.
e. From the ID Type pull-down menu, select Domain name and enter the FQDN of the VPN
firewall; in this example it is "local_id.com".
f. Select Gateway IP Address from the second pull-down menu and enter the WAN IP
address of the VPN firewall; in this example it is "172.21.4.1".
2. From the left side of the menu, click My Identity.
Figure 5-36
Enter the following information:
a. Click Pre-Shared Key and enter the key you configured in the VPN firewall's Add IKE
Policy screen
b. From the Select Certificate pull-down menu, select None.
c. From the ID Type pull-down menu, select Domain Name and create an identifier based
on the name of the IKE policy you created; for example "remote_id.com".
d. Under Virtual Adapter pull-down menu, select Preferred. The Internal Network IP
Address should be 0.0.0.0.
Note: If no box is displayed for Internal Network IP Address, go to Options/
Virtual Private Networking
ProSafe VPN Firewall 200 FVX538 Reference Manual
Global Policy Settings, and check the box for "Allow to Specify Internal
Network Address."
v1.0, January 2010
5-39