NETGEAR FVX538v2 - ProSafe VPN Firewall Dual WAN Reference Manual page 106

ProSafe VPN Firewall 200 FVX538 Reference Manual
Figure 5-4
2. Select Gateway as your connection type.
3. Create a Connection Name. Enter a descriptive name for the connection. This name used to
help you manage the VPN settings; is not supplied to the remote VPN endpoint.
4. Enter a Pre-shared Key. The key must be entered both here and on the remote VPN gateway,
or the remote VPN client. This key must be a minimum of 8 characters and should not exceed
49 characters.
5. Choose which WAN port to use as the VPN tunnel end point.
Note: If you are using a dual WAN rollover configuration, after completing the
wizard, you must manually update the VPN policy to enable VPN rollover.
This allows the VPN tunnel to roll over when the WAN Mode is set to Auto
Rollover. The wizard will not set up the VPN policy with rollover enabled.
5-4
v1.0, January 2010
Virtual Private Networking