Configuring An Ipsec Vpn Tunnel For Remote Access With A Vpn Client - Cisco WS-CE500 Administration Manual

Configuring VPN

Configuring an IPsec VPN Tunnel for Remote Access with a VPN Client

STEP 6
NOTE
Configuring an IPsec VPN Tunnel for Remote Access with a
VPN Client
Cisco SA500 Series Security Appliances Administration Guide
For the example illustrated in
mask of 255.0.0.0.
The IP address range used on the remote LAN must be different from
NOTE
the IP address range used on the local LAN.
Click Apply to save your settings.
The settings are not saved on the Wizard page. The Wizard creates a VPN policy
and an IKE policy based on your entries.
Next steps:
• If you are using the Getting Started (Advanced) page, click Getting Started
> Advanced to return to the list of configuration tasks for Site-to-Site VPN.
• To review or update the configured VPN policy click IPsec > VPN Policies.
For more information, see
• To review or update the configured IKE policy, click IPsec > IKE Policies.
For more information, see
page 144.
• To configure IPsec passthrough, click IPsec > Passthrough. For more
information, see
This section describes how to configure an IPsec VPN tunnel for remote access
with a VPN client, or by using Standard IPsec (Xauth). The VPN Wizard helps you
to set up a tunnel to allow workers to connect to your network from remote
locations by using an IPsec VPN client. After creating the policies through the
Wizard, you can update any of the parameters by using the other options in the
navigation pane.
The Wizard sets most parameters to defaults as proposed by the VPN Consortium
(VPNC), and assumes a pre-shared key, which greatly simplifies setup For
information about the VPNC recommendations, see:
standards.html.
Figure 5, the remote site, Site B, has a subnet
Configuring the IPsec VPN Policies, page
Configuring the IKE Policies for IPsec VPN,
Configuring IPsec Passthrough, page 153.
www.vpnc.org/vpn-
7
148.
139