Cisco WS-CE500 Administration Manual page 143

Configuring VPN
Configuring an IPsec VPN Tunnel for Remote Access with a VPN Client
STEP 4
STEP 5
NOTE
Cisco SA500 Series Security Appliances Administration Guide
- Cisco QuickVPN
X-Auth is an IPsec standard that extends the authentication in native
IPsec to provide user credentials. XAUTH can be used when additional
client security is required with IPsec clients such as Greenbow.
QuickVPN is a propriety Cisco/Linksys client which uses user
authentication but the implementation is specific only to Quick VPN. This
option should be selected when the clients use QuickVPN Client.
• Allow user to change password?: If you chose Cisco QuickVPN for the
Remote Peer Type, you can check this box to allow the user to change the
password.
• Password: Enter an alphanumeric password for this user.
• Confirm Password: Re-enter the characters that you entered in the
Password field.
• LAN IP address: Enter the LAN IP subnet to which the remote user will have
access. The subnet should be part of the LAN or VLAN IP addresses.
• Subnet Mask: Enter the subnet mask for the local subnet.
Click Apply to save your settings.
Repeat as needed for each user that you need to add.
Next steps:
• If you are using the Getting Started (Advanced) page, click Getting Started
> Advanced to return to the list of configuration tasks for IPsec VPN
Remote Access.
• Optionally, review and modify the default settings and policies. See
Advanced Configuration of IPsec VPN, page
• For Cisco QuickVPN, you also must enable Remote Management. See
RMON (Remote Management), page
144.
197.
7
143