Configuring The Lan - Cisco WS-CE500 Administration Manual

Sa500 series small business security appliances
Table of Contents

Advertisement

Networking

Configuring the LAN

STEP 1
STEP 2
STEP 3
Cisco SA500 Series Security Appliances Administration Guide
Configuring the LAN
Click Networking > LAN > IPv4 Config, or from the Getting Started (Basic) page,
under WAN & LAN Connectivity, click LAN Settings.
The IPv4 LAN Configuration window opens.
In the LAN TCP/IP Setup area, enter this information for your security appliance:
IP address: Enter the LAN IP address for the security appliance.
If you change the IP address in this field and click Apply, the security
NOTE
appliance will no longer be at the IP address that you entered in your web
browser to launch the Configuration Utility, and your computer will not longer
be on the same subnet as the security appliance (having received an IP
address through DHCP based on the former address).
After you click Apply, wait a few seconds to allow your computer to obtain a
new IP address from newly assigned IP address pool (or unplug and re-
insert the Ethernet cable to release and renew your IP address). Then enter
the new IP address of the security appliance in the Address bar of the
browser, and log in again.
Subnet mask: Enter the subnet mask for this IP address.
In the DHCP area, configure these settings:
DHCP Mode: Choose one of the following modes:
-
None: Choose this option if the computers on the LAN are configured
with static IP addresses or are configured to use another DHCP server.
-
DHCP Server: Choose this option to allow the security appliance to act
as a DCHP server and to assign IP addresses within the specified range.
Also complete the fields that are highlighted with white backgrounds.
If you want to reserve certain IPs for particular devices, complete this
procedure and then configure the reserved IP addresses. See
Reserved IPs, page
-
DHCP Relay: Choose this option to allow the security appliance to use a
DHCP Relay. If you choose this mode, also enter the IP address of the
Relay Gateway.
Domain Name (optional): Enter a name for the domain.
52.
2
DHCP
44

Advertisement

Table of Contents
loading

Table of Contents