Using The Secondary Firmware; Diagnostics - Cisco WS-CE500 Administration Manual

Administration

Diagnostics

STEP 1
STEP 2
NOTE
Diagnostics
NOTE
STEP 1
STEP 2
Cisco SA500 Series Security Appliances Administration Guide
After a successful upgrade, log in. To verify the firmware version, go to
Status > Device Status. The Firmware Version (Primary) should be the
same as the version that you attempted to install. If the upgrade was
unsuccessful, see
• Reboot: Click Reboot if it is necessary to reboot the router.

Using the Secondary Firmware

You can use this feature to revert to the previous firmware version that was in use.
Click Administration > Firmware & Configuration > Swap Firmware.
The Swap Firmware window opens.
Click Switch to reboot the security appliance by using the secondary firmware
image.
Do not try swap images if a secondary firmware image is not present. Doing so can
cause the to router to not boot up.
You can use the Diagnostics page to assess configuration of the security
appliance and to monitor the overall network health.
These features require an active WAN connection.
Click Administration > Diagnostics.
The Diagnostics window opens.
Perform the following tasks, as needed:
• Ping or Trace an IP Address: You can use these tools to test your network.
- Ping through VPN tunnel: Check the box to enable pinging through the
VPN tunnel. Otherwise, uncheck the box.
Appendix A, "Troubleshooting."
8
180