Ip Routing Mode; Configuring The Ipv6 Wan Connection - Cisco WS-CE500 Administration Manual

Networking
Configuring IPv6 Addressing
STEP 1
STEP 2
STEP 3
STEP 4
NOTE
STEP 1
STEP 2
Cisco SA500 Series Security Appliances Administration Guide

IP Routing Mode

To get started with the IPv6 configuration, first enable IPv4/IPv6 mode. IPv4 and
IPv6 addressing are supported.
Click Networking > IPv6 > Routing Mode.
The Routing Mode window opens.
Click IPv4/IPv6 mode to enable IPv6 addressing, or click IPv4 only mode to
enable only IPv4 addressing.
Click Apply to save your settings.
When the warning appears "An IP Mode change will cause the device to reboot,"
click OK to continue. If you do not want to change the IP mode, click Cancel.
Next steps:
• To configure the WAN connection, click IPv6 > IPv6 WAN Config. For more
information, see
• To configure the LAN, click IPv6 > IPv6 LAN Config. For more information,
see Configuring the IPv6 LAN, page

Configuring the IPv6 WAN Connection

By default, when you enable IPv6 mode, your security appliance is configured to
be a DHCPv6 client of the ISP, with stateless autoconfiguration. If your ISP
assigned a static IPv6 address, or if you need to change the DHCP
autoconfiguration mode, configure the settings on this page.
Click Networking > IPv6 > IPv6 WAN Config.
The IPv6 WAN Configuration window opens.
In the Internet(IPv6) Address area, choose Static IPv6 if your service provider
assigned a fixed (static or permanent) IP address. If you were not assigned a static
IP address, choose DHCPv6.
Configuring the IPv6 WAN Connection, page
80.
2
78.
78