Cisco WS-CE500 Administration Manual page 94

Wireless Configuration for the SA520W
Configuring an Access Point
STEP 5
STEP 6
NOTE
Cisco SA500 Series Security Appliances Administration Guide
• WEP Passphrase: Choose any alphanumeric phrase (longer than 8
characters for optimal security) and click Generate key to generate 4 unique
WEP keys. Select one of the four to use as the static key that devices must
have in order to use the wireless network.
• WEP Key 1-4: If WEP Passphrase is not specified, a key can be entered
directly in one of the WEP Key boxes. The length of the key should be 5 ASCII
characters (or 10 hex characters) for 64-bit WEP and 13 ASCII characters (or
26 hex characters) for 128-bit WEP.
• WEP Key Index: Based on which WEP key box is used, WEP key index is
derived. Different clients can have different numbering scheme for index. For
clients which have indexing starting with 0, WEP Key 1 to WEP Key 4
corresponds to index 0 to 3. Clients which have indexing starting with 1, WEP
Key 1 to WEP Key 4 correspond to index 1 to 4.
Click Apply to save your settings.
Repeat this procedure as needed to add more wireless profiles.
Next steps:
• Required for each access point: Configure and enable the access point.
See Step 2: Configuring the Access Points, page
• If you need to configure advanced settings, click the Advanced Config
button in the List of Profiles table. For more information, see
Advanced Configuration, page
• If you need to configure QoS settings, click the QoS Config button in the
List of Profiles table. For more information, see
Settings for a Wireless Profile, page
• If you want to configure MAC Filtering, click the MAC Filtering button in the
List of Available Access Points table. For more information, see
Wireless Access Based on MAC Addresses, page
• For RADIUS authentication, configure the RADIUS settings. See
RADIUS Server Records, page
98.
95.
Configuring the QoS
95.
96.
193.
3
Profile
Controlling
Configuring
94