Controlling Wireless Access Based On Mac Addresses - Cisco WS-CE500 Administration Manual

Wireless Configuration for the SA520W
Configuring an Access Point
STEP 1
STEP 2
STEP 3
STEP 4
Cisco SA500 Series Security Appliances Administration Guide
• Video: High priority queue, minimum delay. Used typically to send time-
sensitive data such as Video and other streaming media.
• Best Effort: Medium priority queue, medium throughput and delay. Most
traditional IP data is sent to this queue.
• Background: Lowest priority queue, high throughput. Bulk data that requires
maximum throughput and is not time-sensitive is typically sent to this queue
(FTP data, for example).
Click Wireless > Profiles.
The Profiles window opens. The existing profiles appear in the List of Profiles
table.
Find the profile that you want to edit, and click the button in the QoS Config
column.
The QoS Configuration window opens.
Enter the following settings.
• QoS Enable: Check this box to enable QoS for this profile. The settings on
this page apply only if this box is checked.
• Default Class Of Service: Use this setting to specify the default Class of
Service for all traffic on the access point.
• IP DSCP/TOS to Service Mapping: For each IP DSCP/TOS value, leave
Default in the field to apply the selected Default Class of Service, or choose
a particular Class of Service to prioritize the traffic.
Click Apply to save your settings.

Controlling Wireless Access Based on MAC Addresses

This page allows you to define specific MAC addresses to permit or deny access
to the selected access point. The default is "open" access, which means that MAC
filtering is not enabled. Any device can use this access point.
MAC Filtering provides additional security, but it also adds to the complexity and
maintenance. Be sure to enter each MAC address correctly to ensure that the
policy is applied as intended.
3
96