Cisco WS-CE500 Administration Manual page 179

Administration
Firmware and Configuration
STEP 1
STEP 2
Cisco SA500 Series Security Appliances Administration Guide
Wait until the process is complete.
1. Do NOT close the browser window.
2. Do NOT go online.
3. Do NOT turn off or power-cycle the router.
4. Do NOT shut down the computer.
5. Do NOT remove or unmount the USB device.
Click Administration > Firmware & Configuration > USB.
The Firmware & Configuration (USB) window opens.
Perform the following tasks, as needed:
• Mount/Unmount:
- To mount a USB device, insert the device into the USB port. Then click the
Refresh button on the browser toolbar. The Mount button is enabled. Click
Mount.
- To safely remove a USB device, click Unmount.
• Backup / Restore Settings / Software Upgrade
- To save a backup copy of current settings and digital certificates, click
Backup. The file is saved as cisco.cfg.
- To restore the settings from a previously saved configuration file, click
Restore. Locate and select the backup file from the connected USB
storage device. A progress bar indicating the status of the restore
operation will appear. The security appliance automatically restarts.
- To upgrade the firmware, select an upgrade file, and then click Upload to
upload the file, or Upload & Factory Reset to upload the file and reset the
security appliance to the factory default settings. A progress bar will
appear to display the upgrade status.
For information about downloading firmware upgrade files, see
Upgrading the Firmware, page
The router takes several minutes to complete the upgrade. While the
upgrade is in progress, the Test LED on the front panel of the router will
light up. Wait until the light goes off before accessing the router again.
When the image upload is complete, the router automatically restarts.
24.
8
179