Installing A Cd-R Writer In Drive Bay Four - Pioneer DRM-5004X User Manual

4.4 Installing a CD-R Writer in Drive Bay Four

After the DRM-5004X has been set up and tested for the basic two
reader configuration (refer to Chapter 3, Set Up), additional Pioneer
CD-ROM Readers or CD-R Writers may be installed in the next avail-
able drive bays. This section describes steps to follow to custom con-
figure the DRM-5004X by adding a Pioneer CD-R Writer.
NOTE: These instructions can be used to install more than one writer.
4.4.1 Select Additional Drives to be Installed
Decide which additional drives will be needed for the specific applica-
tion. Although two Pioneer CD-ROM Readers are often installed in
the basic DRM-5004X configuration, any combination of up to four
CD-ROM Readers or CD-R Writers can be installed in the DRM-5004X
CD-ROM Jukebox. Writers are usually installed separately, each on
its own separate SCSI bus, so there are no interruptions while data is
being written to the CD-Recordable disc. Install the drive into the next
available drive bay.
NOTE: A special clamper hub that ships with the writer must be
installed into the clamper assembly before the writer is installed. See
page 4-41 for instructions on removing the clamper assembly, then
refer to directions below:
Place the Clamper Hub Bundled with the Writer into the Clamper Assembly
Top Side of
Bottom View of
Clamper Assembly
Clamper Assembly
The Clamper Hub
Plastic
Black Center Gear
Hub
Plastic Hub Tabs
Lock
Surface Plate
Pioneer DRM-5004X CD-ROM Jukebox User's Guide
Replace the original Clamper Hub with the one
bundled with the writer, Part No.DXX2270.
Stand the Clamper Assembly on its Rear Edge and
follow these steps to replace the Clamper Hub:
Rear Edge of Assembly
1. Rotate the Black Center Gear clockwise or
counter-clockwise to move the Surface Plate,
allowing access to the Clamper Hub.
2. Pull back gently on the two Plastic Hub Tabs and
gently push the Hub away from the surface plate,
toward the top side of the Clamper Assembly.
3. Use holes on the top side of the Clamper
Assembly to reach inside and slide the Hub away
Front of Assbly
from the Plastic Hub Lock to release it.
4. Slide the Hub toward the front of the Clamper
Assembly to remove it.
5. Slide the new Clamper Hub into place beneath
the surface plate, seat the Plastic Hub Lock,
snap the Plastic Hub Tabs into place.
Custom Configuration
TP #120 v .1.0 2/95
4
4 - 33